Πρίζα ''Ratio Electric'', Inox 316, 16A, 250V, με προστατευτικό κάλυμμα

Safety regulations and measures

1. The electrical installation must be switched off during installation.

2. Install the power-inlet according to the stated instructions and directions in the manual.

3. Use cables with appropriate wire size. See table “WIRE SIZE”.

 4. Connections and safety features must be executed according to the locally applicable regulations.

Things you need for installation

• Pencil

• Electric drill

• Hole saw

• Drill bit

• Small flat blade screwdriver

• 2.5mm hexagonal socket wrench for the 4mm SS screws

• Cutting / wire stripping pliers

Installation direction

To install the power-inlet, proceed as follows:

1. Make a cut out in ship’s hull using the outline drawings of figure 1.

2. Remove the rear safety enclosure from the inlet.

3. Pull internal wiring through the hull opening.

 4. Thread the wiring through the strain relief on the rear safety enclosure. Slide the mounting gasket over the wiring.

 5. Back off terminal screws on the rear housing of the inlet.

6. Dismantle cable 50 mm, cut back green/yellow wire for 20 mm, strip wire ends 6 mm. Make sure the wire strands are clean and not corroded. If necessary, cut back the wire until clean wire is uncovered. Do not solder the ends of the wire!

 7. Insert wires into the proper colour coded terminal openings (see table “specifications” for the proper colour codes) on the back of the inlet. Tighten terminal screws to 1.6-2.2Nm (14-20 in.-lbs.) torque. Make certain there is no wire insulation under any terminal.

 8. Slide the rear safety enclosure onto the back of the inlet.

9. Position the gasket and inlet over the hull opening, align the mounting holes and attach the inlet to the hull with screws. Install the inlet with the M4 screws included.